Request a Calibration Quote | Morehouse Instrument Company, Inc.

First name(Required)

Last name(Required)

Email(Required)

Phone

Company(Required)

Did Morehouse previously calibrate the instrument?

Do you want the instrument calibrated the same as the previous calibration?

Instrument Information

If you are not sure what you need, a previous certificate may expedite the process. Upload files below:

Drop files here or

Max. file size: 29 MB.

Serial number(s)(Required)

Comments

After submitting this form, a Morehouse representative will contact you to confirm the details of your previous calibration(s).

Type of Instrument(Required)

Serial Number

Specify other type

Manufacturer and Model Number

Asset or ID number

Will you send an indicator?

Indicator paired with load cell (manufacturer, model, and serial number)

Indicator power requirement

Special Indicator Settings

Indicator Channel or Cal Number Programmed to Load Cell

Does the load cell have an amplifier?

Yes

No

What is the voltage into the amplifier?

What is the output for the amplifier?

mA output

Calibration Information

Calibration type

Not sure? Learn more about ASTM E74 and ISO 376

ASTM Class Expectations

Number of coefficients required

Class A Expectations

ISO Class Expectations

Learn more about ISO 376 Calibrations

ISO Case Expectations

Calibration Requirements

Single Run 5 point

Single Run 6 point (5 ascending, 1 descending)

Single Run 10 - 11 point

Dual Run 10 - 11 point

Three run and average

Tolerance / Pass Fail

Other (please specify)

Specify other calibration requirements

Capacity (what it should be calibrated to)(Required)

Capacity (Force Applied) Units(Required)

Calibration Mode

Not sure? Learn more about Compression and Tension Calibration

Direction

Calibration Reporting

Reporting Instructions

Non-linearity

Hysteresis

SEB (Static Error Band)

Tolerance/Accuracy (adjustment criteria)

Resistance value(s)

Program prior to calibration

Other (please specify)

Not sure what you need? Learn more about these Force Measurement Terms

Default decision rule criteria to pass/fail is based on ANSI Z540.3 method 5.

Tolerance/Accuracy value (adjustment criteria)

Tolerance/Accuracy Criteria

Accuracy Value

Count

Fixed Value

Specify Tolerance/Accuracy Value

What shunt value is needed and at which leads?(Required)

Observation Units

Other reporting instructions

Polarity of output (positive or negative in compression or tension)

Is the load cell dual-bridge?

What bridge should be calibrated?

Do you want a net due date listed on the Certificate?

What should the net due date be?

Special Instructions

Describe any specific calibration instructions such as special loading requirements, additional or specific load points, specific load loops, defined procedure to follow, etc.

Instrument Information

Calibration Information

Calibration Reporting

Special Instructions

Products

Calibration

SAles

Support

General

Instrument Information

Calibration Information

Calibration Reporting

Special Instructions

Products

Calibration

SAles

Support

General

Type

Subscribe to our newsletter